Using the System

Initialisation

JaguarVoice is ready to operate 10 seconds after the ignition switch is turned to position ‘II’ (ignition on).

Driver Voice Controls

The voice button is on the left-hand side of the steering wheel, see ‘Steering wheel voice switches’, page 106.

Some examples of using the system are provided on the following pages for you to try.

Note: The system will not operate until the radio security code has been entered.

Voice commands to the navigation system will only operate after the navigation caution screen has been cleared. This must be done after every ignition cycle.

Rear Occupant Voice Controls

There are two voice buttons on the XJ rear multimedia switchpack, see items 7 and 8 Voice button – right and Voice button - left respectively, on the previous illustration.

These can be operated in two different modes:

Cabin mode – When the cabin mode button is pressed, or when the light on the button is illuminated, then the rear occupants can control the audio playing through the cabin speakers. Simply press the voice button and give a command.

Headphone mode – When the LEFT button is pressed, or when the light on the button is illuminated, then the left occupant is in headphone mode (the right headphones control is equivalent to the left).

In headphone mode, each occupant can control the audio in their own headphones by using their respective voice button, and issuing a voice command.

107

Page 107
Image 107
Jaguar JJM 18 42 26 701 manual Using the System, Initialisation, Driver Voice Controls, Rear Occupant Voice Controls, 107