Using the System
Some Useful Notes
•Only one person at a time can use the voice system.
•Excessive noise, for example while driving with windows open or in demist mode, may cause voice command misrecognition. If it is too noisy to use the phone, it is likely that voice commands will not be recognised.
•Voice commands cannot be given while hands free phone call or radio traffic announcement is in progress.
•If the voice button is pressed whilst a radio traffic announcement is in progress the announcement will be cancelled. Press the voice button again to start a voice session.
•While ‘LISTENING’ is displayed on the message centre, the command can be cancelled by pressing the same voice button (could be a rear voice button in the XJ) that was used to start the voice session, except when using the ‘PHONE ENTER’ command. To cancel a ‘PHONE ENTER’ voice session either say ‘CANCEL’ when ‘LISTENING’ is displayed or press the voice button and after the end of the beep say ‘CANCEL’. During a store nametag session, if the voice button is pressed and released during ‘LISTENING’, the system will cancel after up to 2 seconds.
•Voice feedback can be interrupted by pressing the voice button that was used to start the voice session, whilst the feedback is playing.
•After starting to speak, the command must be completed within 10 seconds.
•During a voice command the audio system and direction indicator ticking will be muted.
•The voice session will be cancelled if an alternative message requires the display/speaker (e.g. incoming phone call or radio traffic announcement).
