3. Front panel

1

2

3

1.[PHONE] jack

Connect a set of headphones to this jack (stereo mini).

2.[PHONE LEVEL] knob: 0...10

This knob adjusts the volume of the headphones. Higher settings will produce a louder volume.

3.[INPUT TRIM] knob: 0...10

This knob adjusts the input level.

Raising the level of the [INPUT TRIM] knob when nothing is connected to an input jack will produce hum or noise.

Introduction

4.Rear panel

12 3

1.[POWER/BACK LIGHT] switch

This switch turns the power on/off, and turns the dis- play backlight on. (→ p.14)

2.[DC 4.5V] connector

Connect the included AC adapter to this connector.

3.[USB] connector

Use a USB cable to connect this to your computer. (→ p.52)

5.Bottom panel

1.[GUITAR INPUT] switch

Set this switch according to the output level of the gui- tar that is connected to the [GUITAR INPUT] jack. LOW: Use this setting when using a guitar with low output pickups (such as a single coil pickup).

HIGH: Use this setting when using a guitar with high output pickups.

If you are not sure which setting is appropriate, set this to LOW. If the sound is still distorted when the [INPUT TRIM] knob is in the minimum position, set this switch to HIGH.

9

Page 11
Image 11
Korg PXR4 owner manual Front panel, Rear panel, Bottom panel