14. Battery empty icon
This will blink when the battery runs low. (→ p.14)
15.Effect chain
This area indicates the on/off status of each effect module.
16.Display indicator
These indicate the type of level that is shown by the level meters.
PRE: The meters show the
POST: The meters show the
MIXER: The level meters indicate the value of the parameter (LEVEL, PAN, SENDL, SENDR) selected in the mixer display for each track.
17.Mixer indicator
This area indicates the parameter that you are editing in Mixer mode.
LEVEL: You are in the page that sets the audio level of each track.
PAN: You are in the page that sets the stereo left/right position of each track.
SENDL: You are in the page that sets the effect depth for the left channel of each track.
SENDR: You are in the page that sets the effect depth for the right channel of each track.
18.Effect assign indicator (→ p.67)
This area indicates the effect type (effect insertion location).
GUITAR: A guitar effect is selected.
INSERT: An insert effect is selected.
MASTER: A master is selected.
Introduction
FINAL: A final effect is selected.
19.Bounce indicator (→ p.68)
This indicates the type of bounce recording.
4→ 2: Four tracks of audio will be recorded into two or
one of the tracks.
2+2→ 2: Two tracks of audio and two external audio signals will be recorded into two tracks. Three tracks of audio and one external audio signal can also be recorded onto one track.
DUB: Individual tracks will be recorded one at a time.
CONV: Convert
20.Original value icon
This will light when the effect parameter is at the same value as when it was stored. This will go dark when you edit the parameter.
21.Effect parameters
These will light to indicate parameters that exist for each effect module in the effect page, allowing you to use the faders to edit them. The indicator for the cur-
11
