Lexmark 200, 20E manual Incorrect language appears on the display, Software did not install

Troubleshooting 137

Incorrect language appears on the display

If the "Before you troubleshoot" checklist does not solve the problem, then try the following:

CHANGE THE LANGUAGE USING THE PRINTER MENUS

1From the home screen, navigate to:

> Device Setup > Language

2Select a language, and then touch Accept.

3 Touch Yes to confirm this setting.

Software did not install

If you encountered problems while installing, or if your printer does not appear in the list in the printers folder or as a printer option when sending a print job, then try uninstalling and reinstalling the software.

Before you reinstall the software, do the following:

MAKE SURE THAT YOUR COMPUTER MEETS THE MINIMUM SYSTEM REQUIREMENTS

TEMPORARILY DISABLE SECURITY PROGRAMS IN WINDOWS BEFORE INSTALLING THE SOFTWARE

CHECK THE USB CONNECTION

1Check the USB cable for any obvious damage. If the cable is damaged, then use a new one.

2 Firmly plug the square end of the USB cable into the back of the printer.

3Firmly plug the rectangular end of the USB cable into the USB port of the computer.

The USB port is marked with .

Note: If you continue to have problems, then try another USB port on the computer. You may have connected to a defective port.

RECONNECT THE PRINTER POWER SUPPLY

1Turn off the printer.

Note: Make sure the printer is not in Sleep mode. Press and hold for three seconds to turn off the printer.

2Unplug the power cord from the wall outlet, and then pull out the power cord from the power supply.

3After one minute, reconnect the power cord into the power supply, and then plug the power cord into the wall outlet.

4Turn on the printer.

Recovering the security PIN of the printer

Contact customer support.