3Firmly plug the rectangular end of the USB cable into the USB port of the computer.
The USB port is marked wit h .
Note: If you continue to have problems, then try another USB port on the computer. You may have connecte d to
a defective port.
REMOVE AND REINSTALL THE PRINTER SOFTWARE
Printer is printing blank pages
Blank pages may be caused by improperly installed ink cartridges .
REINSTALL THE INK CARTRIDGES AND DEEP CLEAN AND ALIGN THE PRINTHEAD
1Reinstall the ink cartridges. For more information, see “Rep lacing ink cartridges” on pa ge 14.
If the cartridges do not seem to fit, then make sure the printhead is properly seated, and then try installing the
cartridges again.
2Load plain paper.
3From the home screen, navigate to:
> More Options > Deep Clean Printhead
A cleaning page prints .
4Navigate to:
> More Options > Align Printer
An alignment page prints.
Note: Do not remove the alignment page until printing is finished.
Printer is busy or does not respond
If the "Before you troubleshoot" checklist does not solve the problem, then try one or more of the following:
MAKE SURE THE PRINTER IS NOT IN POWER SAVER MODE
If the power light is blinking on and off slowly, th en the printer is in Power Saver mode. Pres s to wake up the
printer.
If the printer will no t come out of P ower Saver mode, then reset the p ower:
1Unplug the power cord from the wall outlet, and then wait 10 seconds.
2Insert the power cord into the wall outlet, and then turn on the printer.
If this problem persists, then check our Web site for updates for your printer software or firmware.
Troubleshooting
134