Linksys SPA932, SPA962 Setting Optional Network Parameters, Optional Network Configuration Notes

Setting System Features

Setting Optional Network Parameters

6.Scroll to 9 Non-DHCP Subnet Mask. Press Edit, then enter the subnet mask of the phone using the asterisk (*) in place of periods. For example, the IP address 255.255.255.0 would be entered as 255*255*255*0. Press OK.

7.Scroll to 10 Non-DHCP Default Route. Press Edit, then enter the default gateway of the phone using asterisks as shown above. Press OK.

8.Scroll to 11 Non-DHCP DNS 1. Press Edit, then enter the DNS1 of the phone using asterisks as shown above. Press OK. Optionally scroll to 12 Non-DHCP DNS2.

9.Press the Save soft button.

NOTE: If you do not press Save, your changes are not applied. To cancel your changes, press the Cancel softkey.

Setting Optional Network Parameters

Optional Network Configuration Notes

•HostName: Enter the host name of the SPA9x2 phone.

•Syslog Server: Enter the syslog server name and port. The syslog server logs SPA9x2 system information and critical events. If you enter both a Debug Server and a Syslog Server, syslog messages are also logged to the debug server.

•Debug Server: Enter the debug server name and port. This feature specifies the server for logging SPA9x2 debug information. The level of detailed output depends on the debug level parameter setting (below).

•Debug Level: Enter a value from 0-3. The highest level, 3, is recommended because the higher levels provide more debug information. To log SIP messages, you must set this value to 2 or 3. To limit debug information, set this parameter to a low value such as 0 or 1. Defaults to 0.

•Primary NTP Server and Secondary NTP Server: Enter an IP address or hostname for the NTP Server. The phones use these servers to synchronize its time. Defaults to blank.

Linksys SPA9x2 Phone Administration Guide 43