Linksys SPA962, SPA942 Setting SIP Parameters, see , Using the SPA932 Sidecar, Description

Setting SIP Parameters

SIP Parameters

Parameter	Description
SIP-B Enable	If set to yes, enables Sylantro call features. See www.sylantro.com for
	more information.
	Defaults to no.
Talk Package	If set to yes enables support for the Broadsoft Talk Package, which lets
need info	users answer or resume a call by clicking a button in an external
	application.
	Defaults to no.
Hold Package	If set to yes, enables support for the Broadsoft Hold Package, which lets
need info	users place a call on hold by clicking a button in an external application.
	Defaults to no.
Conference Package	If set to yes, enables support for the Broadsoft Conference Package, which
need info	enables users to start a conference call by clicking a button in an external
	application.
	Defaults to no.
Notify Conference	If set to yes, the SPA9x2 sends out a NOTIFY with event=conference when
need info	starting a conference call (with the Broadsoft Conference Package).
	Defaults to no.
RFC 2543 Call Hold	If set to yes, the SPA9x2 includes SDP syntax c=0.0.0.0 when sending a SIP
	re-INVITE to a peer to hold the call.
	If set to no, the SPA9x2 does not include the c=0.0.0.0 syntax in the SDP.
	With either setting, the phone includes a=sendonly syntax in the SDP.
	Defaults to yes.
Random REG CID On	If set to yes, the SPA9x2 uses a different random call-ID for registration
Reboot	after the next software reboot.
	If set to no, theSPA9x2 tries to use the same call-ID for registration after
	the next software reboot.
	With either setting the phone uses a new random call-ID for registration
	after a power-cycle.
	Defaults to no.
SIP TCP Port Min	Specifies the lowest TCP port number that can be used for SIP sessions.
	Defaults to 5060.
SIP TCP Port Max	Specifies the highest TCP port number that can be used for SIP sessions.
	Defaults to 5080.
CTI Enable	If set to yes, enables the computer telephony integration (CTI), where a
	computer can act as a call center handling all sorts of incoming and
	outgoing communications. , including phone calls, faxes, and text
	messages. The CTI interface allows a third-party application to control and
	monitor the state of a SPA9x2 and, for example, initiate or answer a call by
	clicking a mouse on a PC,
	Note CTI must be enabled on the SPA962 for an attached SPA932 to
	properly monitor the SPA962's line status. If setting up a SPA932,
	see Chapter 10, "Using the SPA932 Sidecar."
	Defaults to no.

Linksys SPA9x2 Phone Administration Guide 47