Lucent Technologies P332MF manual Cajun Campus CLI Layer, User Level Commands

Chapter 6

Cajun Campus CLI – Layer 2

This chapter provides instructions for the configuration of your Cajun P330 using the text-based Cajun Campus Command Line Interface (CLI or Terminal Emulation). You can also configure your Cajun P330 using the Cajun P330 Manager with its graphical user interface (see Appendix A).

The configuration procedure involves establishing a Telnet session or a serial connection and then using the Cajun P330’s internal CLI. See Chapter 5 for instructions on how to establish a Telnet session or serial connection, and for a description of CLI conventions.

The CLI is command-line driven and does not have any menus. To activate a configuration option, you must type the desired command at the prompt and press Enter.

User Level Commands

This section describes all commands that are available from the User level.

Following is a table of the User Level commands and command groups (all commands are also available at the higher levels).

• session	Opens a session to another Cajun P330 module	Page 38
	or X330 ATM Access module
• terminal width	Display or set the width of the terminal display	Page 38
• terminal length	Display or set the length of the terminal display	Page 38
• clear screen	Clears the current terminal display	Page 39
• show1	Shows the current switch parameters	Page 39
• ping	Sends ICMP echo request packets to another	Page 39
	node on the network
• dir	Show files in the System	Page 60

1This command corresponds to a group of commands and is shown in a separate Table on Page 39

Cajun P332MF User’s Guide 37