Chapter 6 Cajun Campus CLI – Layer 2
Clear screen Command
The clear screen command clears the current terminal display.
The syntax for this command is:
clear screen
Ping Command
Use the ping command to send ICMP echo request packets to another node on the network.
The syntax for this command is:
ping [host[number]]
host | Host IP address/Internet address of route destination. If missing then |
| the last host IP is used. |
number | Number of packets to send. If missing then the last number is used |
Note: You can use this command via the Master module only.
Example:
To ping the IP number 149.49.48.1 ten times:
ping 149.49.48.1 10: 56 databytes
64 bytes from 149.49.48.1: icmp_seq=0. time=8 ms
Show Commands Summary Table |
|
|
Following is a table of the | show commands: |
|
• show time | Show current time | Page 41 |
• show timezone | Show the current timezone offset | Page 41 |
• show ntp | Display the current Network Time | Page 41 |
| Protocol (NTP) status and parameters |
|
• show ip route | Show IP routing table entries | Page 42 |
• show image | Show the image version | Page 42 |
version |
|
|
• show snmp | Show SNMP community strings | Page 43 |
• show snmp retries | Show SNMP retries number | Page 43 |
• show snmp timeout | Show SNMP timeout | Page 43 |
Cajun P332MF User’s Guide | 39 |
