Chapter 6 Cajun Campus CLI – Layer 2

Set interface Command

Use the set interface command to configure the management interface on the Master agent of the stack.

The syntax for this command is:

set interface inband <vlan> <ip_addr> <netmask>

inband

Interface name used for the management

vlan

The number of the VLAN to be used for management

ip_addr

IP address used for managing the stack

netmask

Subnet mask of the management interface

Example:

Cajun_P330-N# set interface inband 1 149.49.42.252 255.255.255.0 Interface inband IP address set.

You must reset the device in order for the change to take effect.

Set port level Command

Use the set port level command to set the priority level of a port. Packets traveling through a port set at normal priority should be served only after packets traveling through a port set at high priority. Packets traveling with a 802.1p priority header are not affected by this command.

The syntax for this command is:

set port level <mod_num>/<port_num> {normalhigh}

normal

Set the port priority to regular.

high

Set the port priority to high.

Example:

To set the priority level for port 2 on module 1 to high:

Cajun_P330-N# set port level 1/2 high

Port 1/2 port level set to high.

74

Cajun P332MF User’s Guide

Page 88
Image 88
Lucent Technologies P332MF manual Set interface Command, Set port level Command