Chapter 6 Cajun Campus CLI – Layer 2

Set port negotiation Command

Use the set port negotiation command to enable or disable autonegotiation on a port. For 10/100Base-T ports, autonegotiation determines the speed and the duplex mode; for 1000Base-X ports it will determine the flow control (pause) mode only; meaningless for 100Base-F ports. If autonegotiation is disabled, you can set these port parameters using the relevant CLI commands (if autonegotiation is enabled, these commands have no effect).

The syntax for this command is:

set port negotiation <mod_num>/<port_num> {enabledisable}

Example:

To disable autonegotiation on port 1, module 4:

Cajun_P330-N# set port negotiation 4/1 disable

Link negotiation protocol disabled on port 4/1.

Set port enable Command

Use the set port enable command to enable a port or a range of ports.

The syntax for this command is:

set port enable [mod_num/port_num]

mod _num

Number of the module

port_num

Number of the port.

Example:

To enable port 3 on module 2:

Cajun_P330-N# set port enable 2/3

Port 2/3 enabled.

Set port disable Command

Use the set port disable command to disable a port.

The syntax for this command is:

set port disable <mod_num>/<port_num>

Example:

Cajun_P330-N# set port disable 5/10

Port 5/10 disabled.

Cajun P332MF User’s Guide

75

Page 89
Image 89
Lucent Technologies P332MF manual Set port negotiation Command, Set port enable Command, Set port disable Command