Chapter 6 Cajun Campus CLI – Layer 2

Session Command

Use the session command to open a session with a specific entity in a module of the stack. For example, you can open a session with the Routing entity of a Cajun P333R module in the stack, or with an the X330 ATM module entity plugged into a specific module.

The syntax for this command is:

session [<mod_num> [switchrouteratm]]

mod_num

(optional) Number of the module.

 

If you do not specify this parameter, you will get the default

 

entity of the stack (Layer 2 session to the Master)

switchrouteratm

(optional) The entity to which you want to open a session

 

If you do not specify this parameter, you will get the default

 

entity of the specific module:

 

switch - Layer 2 entity of the module (see Note below)

 

router - Cajun P333R Routing entity

 

atm - X330 Access module ATM entity

Note: Layer 2 commands are only available if you open a switch session with the Master module.

Router commands are described in the Cajun P333R User’s Guide.

Example:

Cajun_P330-N# session 2 router

Note: When you use the session command the security level stays the same.

Terminal Commands

Use the terminal width and terminal length commands to set the width and length of the terminal display in characters.

The syntax for this command is:

terminal {widthlength} [<characters>]

38

Cajun P332MF User’s Guide

Page 52
Image 52
Lucent Technologies P332MF manual Session Command, Terminal Commands, Terminal widthlength characters