
Motorola Netopia® Router CLI Commands 2-33
Note: The commands in this section are supported beginning with firmware version 8.2.
interface ethernet id ip
show interface ethernet id ip
These commands allow you to set, disable, or show the status of stateful inspection for the specified interface. This option is disabled by default. Stateful inspection prevents unsolicited inbound access when NAT is disabled.
interface ethernet id ip
show interface ethernet id ip
These commands allow you to set, disable, or show the status of default mapping to router for the specified interface.
interface ethernet id ip
These commands allow you to set or show TCP sequence difference acceptable for the specified interface. The TCP sequence number difference maximum allowed value is 65535. If the value of
interface ethernet id ip
show interface ethernet id ip
These commands allow you to set, disable, or show whether fragmented packets are received for the specified interface.
interface ethernet id ip
show interface ethernet id ip
These commands allow you to set, disable, or show the status of a stateful inspection exposed address list for the specified interface. Exposed address lists are similar to NAT server lists. Exposed addresses in the list will not be subject to stateful inspection and hence unsolicited inbound traffic will be allowed to these addresses.
These are active only if NAT is disabled on the profile.