Netopia CLI 874 manual IP NAT Passthrough Commands

3-20 Command Line Interface Commands Reference

cp id ip rip auth key id end date date show cp id ip rip auth key id end date

These commands allow you to set or show an end date for the RIP-2 Authentication key(s) on the specified Connection Profile. The acceptable year range is from 1904 – 2039.

cp id ip rip auth key id end time time show cp id ip rip auth key id end time

These commands allow you to set or show an end time for the RIP-2 Authentication key(s) on the specified Connection Profile.

cp id rip auth key id end time mode { infinite date } show cp id ip rip auth key id end time mode

These commands allow you to set or show the end time mode for the RIP-2 Authentication key(s) on the specified Connection Profile. date specifies that an expiration date and time will be used; infinite specifies that the key will never expire.

cp id rip auth key id key <string>

These commands allow you to assign a RIP-2 Authentication key on the specified Connection Profile. Keys must be manually entered and must consist of 1 – 16 ASCII characters each.

IP NAT Passthrough Commands

Note: The commands in this section are supported beginning with Firmware Version 8.2.

cp { name index } ip nat passthrough enable { yes no } no cp { name index } ip nat passthrough enable

show cp { name index } ip nat passthrough enable

These commands allow you to enable, disable, or show the NAT passthrough behavior for the specified Connection Profile. The IP passthrough feature allows for a single LAN PC to have the router’s public address assigned to it, in addition to providing PAT (NAPT) via the same public IP address for all other hosts on the private LAN subnet.

cp { name index } ip nat passthrough dhcp enable { yes no } no cp { name index } ip nat passthrough dhcp enable

show cp { name index } ip nat passthrough dhcp enable

These commands allow you to enable, disable, or show the NAT passthrough DHCP behavior for the specified Connection Profile. This governs DHCP addressing for the passthrough host.

cp { name index } ip nat passthrough dhcp mac-address { mac-address} show cp { name index } ip nat passthrough dhcp mac-address

These commands allow you to set or show the NAT passthrough DHCP MAC address for the specified Connection Profile. This specifies the MAC address of the passthrough host.