3-22 Command Line Interface Commands Reference

cp { name index } ip state-insp xposed-list xposed-list_nameno cp { name index } ip state-insp xposed-list

show cp { name index } ip state-insp xposed-list

These commands allow you to set, disable, or show the status of a stateful inspection exposed address list for the specified Connection Profile. Exposed address lists are similar to NAT server lists. Exposed addresses in the list will not be subject to stateful inspection and hence unsolicited inbound traffic will be allowed to these addresses.

These are active only if NAT is disabled on the profile.

cp { name index } ip state-insp tcp-seq-diff diff show cp { name index } ip state-insp tcp-seq-diff

These commands allow you to set or show TCP sequence difference acceptable for the specified Connection Profile.

cp { name index } ip state-insp router-access { yes no on off } no cp { name index } ip state-insp router-access

show cp { name index } ip state-insp router-access

These commands allow you to set, disable, or show the status of default mapping to router for the specified Connection Profile.

cp { name index } ip state-insp deny-frag { yes no on off } no cp { name index } ip state-insp deny-frag

show cp { name index } ip state-insp deny-frag

These commands allow you to set, disable, or show whether fragmented packets are received for the specified Connection Profile.

L2TP Connection Profile Configuration Commands

Note: The commands in this section are supported beginning with Firmware Version 8.2.

cp { name index } l2tp ip partner ip-addrshow cp { name index } l2tp ip partner

These commands allow you to specify or show the partner Ipv4 address associated with the local L2TP tunnel.

cp { name index } l2tp ip via ip-addr show cp { name index } l2tp ip via

These commands allow you to specify or show a gateway address at which the partner address may be reached when the partner IP and the remote IP addresses are on the same subnet.

cp { name index } l2tp authentication enable { yes no } show cp { name index } l2tp authentication enable

These commands allow you to enable, disable or show the status of L2TP CHAP-like tunnel authentication for the specified profile.

Page 166
Image 166
Netopia CLI 874 manual L2TP Connection Profile Configuration Commands