Netopia CLI 874 manual Differentiated Services Diffserv commands

2-56 Command Line Interface Commands Reference

Differentiated Services (Diffserv) commands

Note: The commands in this section are supported beginning with Firmware Version 8.4.2.

Diffserv Configuration Commands

diffserv enable [ yes no ] diffserv ratio [ 79 - 100 ] diffserv rule id name string

diffserv rule id protocol [ tcp udp icmp other ] diffserv rule id priority [ off assure expedite reserve ] diffserv rule id direction [ outbound inbound both ] diffserv rule id start-port [ 0 - 49151 ]

diffserv rule id end-port [ 0 - 49151 ] diffserv rule id inside-ip x.x.x.x diffserv rule id outside-ip y.y.y.y

diffserv enable [ yes no ]

This command allows you to enable or disable Differentiated Services (diffserv) for controlling Quality of Service (QoS) queue priority.

diffserv ratio [ 79 - 100 ]

This command allows you to set the low-high ratio to regulate the level of packets allowed to be pending in the low priority queue.

diffserv rule id name string

This command allows you to create a custom rule specified by id with the name string. If your applications do not provide Quality of Service (QoS) control, rules allow you to define streams for some protocols, port ranges, and between specific end point addresses.

diffserv rule id protocol [ tcp udp icmp other ]

This command allows you to specify the protocol for the rule id: tcp, udp, icmp, or other. other is appropriate for rules on protocols with non-standard port definitions. IPSEC and PPTP are common examples. If you specify other protocol, you must provide its actual protocol number, with a range of 0 – 255.