Netopia CLI 874 manual Command Line Interface Commands Reference

2-64 Command Line Interface Commands Reference

interface t1 id framing { d4 esf } show interface t1 id framing

These commands set or display the framing mode for the specified T1 WAN interface.

interface t1 id encoding { ami b8zs } show interface t1 id encoding

These commands set or display the line encoding for the specified T1 WAN interface.

Note: If this command changes the line encoding from b8zs to ami and there are two or more contiguous Nx64k channels in use, the channel data rate will be changed to Nx56k.

interface t1 id operation line type { normal copper-mountain } show interface t1 id operation line type

These commands set or display the operation mode for the specified T1 WAN interface. The keyword copper-mountainshould be specified when connected to a Copper Mountain DSLAM T1 line card; the keyword normal should be specified in all other situations.

interface t1 id prm-enable { yes no } show interface t1 id prm-enable

no interface t1 id prm-enable

These commands set or display whether or not ANSI PRMs are sent on the specified T1 WAN interface.

interface t1 id rfc1973 enable { yes no } show interface t1 id rfc1973 enable

no interface t1 id rfc1973 enable

These commands set or display whether or not PPP in Frame Relay (RFC1973) is enabled on the specified T1 WAN interface.

interface t1 id rfc1973 dlci { 16..991 } show interface t1 id rfc1973 dlci

These commands set or display the DLCI used for PPP in Frame Relay (RFC1973) on the specified T1 WAN interface.

interface t1 id rfc1973 lmi { annexa annexd ansi ccitt lmi none } show interface t1 id rfc1973 lmi

no interface t1 id rfc1973 lmi

These commands set or display the Local Management Interface (LMI) type for PPP in Frame Relay (RFC1973) on the specified T1 WAN interface.