Motorola Netopia® Router CLI Commands 2-67

show interface t1 id line status

This command displays the line status on the specified T1 interface. This will display one of the following strings:

Red Alarm

Yellow Alarm

Blue Alarm

Normal Operation

show interface t1 id loopback mode

This command displays the loopback mode of the specified T1 interface. This will display one of the following strings:

Layer 1 Activation Not Present

Local Payload Loopback Enabled

Remote Line Loopback Enabled

Remote Payload Loopback Enabled

Clear - No Loopback Enabled

show interface t1 id loopback status

This command displays the progress of the loopback test on the specified T1 interface. This will display one of the following strings:

Loopback Not Active

PASS (xxxxx good, yyyyy bad packets)

FAIL (xxxxx good, yyyyy bad packets)

Examples:

#show interface t1 1 loopback status Loopback Not Active

#interface t1 1 diagnostic mode send loopback #show interface t1 1 loopback status

PASS (00255 good, 00000 bad packets) #show interface t1 1 loopback status FAIL (00000 good, 00256 bad packets)

Page 79
Image 79
Netopia CLI 874 manual Red Alarm Yellow Alarm Blue Alarm Normal Operation