Netopia CLI 874 manual Motorola Netopia Router CLI Commands

Motorola Netopia® Router CLI Commands 2-35

interface ethernet id ip vrrp vrouter id preempt-mode enable [ no yes on off ] show interface ethernet id ip vrrp vrouter id preempt-mode enable

These commands allow you to enable, disable, or display the status of preempt mode. The default is enabled.

interface ethernet id ip vrrp vrouter id enable [ no yes on off ] show interface ethernet id ip vrrp vrouter id enable

These commands allow you to enable, disable, or display the status of the Virtual Router.

no interface ethernet id ip vrrp vrouter id

This command allows you to delete a Virtual Router.

show interface ethernet id ip vrrp wan-monitor enable [ { yes no on off } ] show interface ethernet id ip vrrp wan-monitor enable

These commands allow you to enable, disable, or display the status of the WAN monitor.

interface ethernet id ip vrrp master-dhcp-srv enable [ { yes no on off } ] show interface ethernet id ip vrrp master-dhcp-srv enable

These commands allow you to enable, disable, or display the status of the DHCP behavior. The Virtual Router can either serve or relay DHCP only if it is in Master state.

interface ethernet id ip vrrp dhcp-gateway ip-addrshow interface ethernet id ip vrrp dhcp-gateway

These commands allow you to specify or display the Virtual Router DHCP gateway IP address.