Netopia CLI 874 manual Show interface ethernet 0 ip rip receive

Motorola Netopia® Router CLI Commands 2-27

interface ethernet id address-serve dhcp option 150 address www.xxx.yyy.zzz no interface ethernet id address-serve dhcp option 150 address www.xxx.yyy.zzz show interface ethernet id address-serve dhcp option 150 address

Note: These commands are supported beginning with firmware version 8.6.

These commands allow you to configure, remove, or show up to four TFTP IP addresses per ALAN to be served via option 150.

interface ethernet id ip rip exclude-wan-routes no interface ethernet id ip rip exclude-wan-routes show interface ethernet id ip rip exclude-wan-routes

Note: These commands are supported beginning with firmware version 8.7.

These commands allow you to specify, disable, or show the status of broadcasting WAN routes via RIP. This is available only if rip transmit is enabled for the interface. The default is no, but if enabled, will drop any RIP routes with non-LANside information from RIP updates sent over the interface.

interface ethernet id ip rip receive { no v1 v2 both v2-md5 } no interface ethernet id ip rip receive

show interface ethernet id ip rip receive

These commands allow you to set, delete, or show the RIP receive behavior of the specified Ethernet interface.

Example:

show interface ethernet 0 ip rip receive

interface ethernet id ip rip transmit { no v1 v2broadcast v2multicast v2broadcast-md5 v2multicast-md5 }

no interface ethernet id ip rip transmit show interface ethernet id ip rip transmit

These commands allow you set, delete, or show the RIP transmit behavior of the specified Ethernet interface.

Examples:

show interface ethernet 0 ip rip transmit

interface ethernet id ip rip auth key id no interface ethernet id ip rip auth key id

show config interface ethernet id ip rip auth key

These commands allow you to create, delete, or show the RIP-2 Authentication key(s) on the specified interface.