Netopia CLI 874 manual ARP Configuration Commands, Show arp static Clear arp-cache Show arp-cache

Motorola Netopia® Router CLI Commands 2-97

ARP Configuration Commands

ARP Configuration Commands

arp ip-addr hw-address
arp ip-addr hw-address inter face-id	(D7100 CSU only)
no arp ip-addr hw-address
show arp static
clear arp-cache
show arp-cache

Note: The hw-addressformat for an Ethernet MAC address is six hexadecimal values between 00 and FF inclusive separated by colons. Thus, the following is an example of a valid Ethernet MAC address hw-address:

00:00:C5:70:00:04

arp ip-addr hw-address

arp ip-addr hw-address inter face-id (D7100 CSU only)

This command allows you to create or modify a global ARP cache entry. If the model number of the Motorola Netopia® router is D7100 (CSU), then the interface-id is required so that the device knows the interface with which to associate the ARP entry.

no arp ip-addr hw-address

This command allows you to remove a global ARP cache entry. Note that this does not affect entries in the interface-specific caches acquired via ARP requests and responses. To flush the interface-specific ARP caches, use the clear arp-cachecommand, described below.

show arp static

This command displays global ARP cache entries configured using the arp command described above.

clear arp-cache

This command allows you to flush all of the interface-specific ARP caches. It does not affect any entries in the global ARP cache, described above.

show arp-cache

This command allows you to display the global ARP cache as well as the ARP cache for each active interface that supports ARP.