Motorola Netopia® Router CLI Commands 2-9
snmp
Note: These commands are supported beginning with firmware version 8.2.
These commands allow you to set, show, or delete the SNMP heartbeat interval. A single configuration item governs heartbeat traps, the time interval between traps. Permitted values are 0 – 65535 minutes. A value of zero, the default, means the trap is disabled. This value can be configured by the CLI and SNMP. When the interval value is set to a positive number, a trap is sent immediately and the new (or same) interval value takes effect.
snmp notify type [
Note: This command is supported beginning with firmware version 8.4.2.
This command allows you to set the type of SNMP traps that the system will generate: v1, v2(c), or, beginning with Firmware Version 8.4.2, inform.
snmp system contact string show snmp system contact no snmp system contact
These commands set, display, or clear the router's SNMP system contact (sysContact) string.
snmp system location string show snmp system location no snmp system location
These commands set, display, or clear the router's SNMP system location (sysLocation) string.
snmp system name string show snmp system name no snmp system name
These commands set, display, or clear the router's SNMP system name (sysName) string.
snmp system trap source address [ lan wan ]
Note: This command is supported beginning with firmware version 8.5.
This command allows you to specify whether the source address for SNMP traps should be on the LAN or the WAN. When this parameter is set to lan, all SNMP v2 and inform traps use the source IP address of the primary LAN interface. Otherwise, the IP address of the WAN interface is used.
system syslog enable { yes no } no system syslog enable
show system syslog enable
Note: These commands are supported beginning with Firmware Version 8.2.
