
Motorola Netopia® Router Connection Profile Commands 3-11
cp { name index }
This command allows you to create a connection profile, which is a structure used to define WAN connections. index can be any value from 1 to 16. The command has no effect if the profile already exists. The name of the profile defaults to “profile index” (e.g., “profile 1”).
no cp { name index }
This command allows you to delete a connection profile.
cp { name index } enable { yes no }
This command allows you to enable or disable connection profile index. Use this command if you want to temporarily disable a profile but do not want to lose its configuration.
cp { name index } tag string
This command allows you to name connection profile string, which can be up to 32 characters long.
cp { name index } dle { hdlc ppp
This command allows you to set the encapsulation type that the connection profile will use when establishing a WAN connection. Note that a profile whose encapsulation type is incompatible with the global encapsulation type is essentially disabled and cannot be used. Also, when a profile is created, it inherits the global encapsulation type by default and thus it is not usually necessary to explicitly set this parameter.
Note: atmfuni is accepted as a synonym for rfc1483, and
Beginning with Firmware Version 8.3.1, the following optional modifiers are permitted if the specified DLE is ppp:
and the following optional modifiers are permitted if the specified DLE is rfc1483:
{bridged routed }
cp { name index } pppoe
Note: These commands are supported beginning with firmware version 8.5.
These commands allow you to enable, disable, or show the status of PPPoE/PPPoA autodetection.
If you are using PPP, and you have selected