Netopia CLI 874 manual Stateful Inspection Configuration Commands

2-32 Command Line Interface Commands Reference

interface ethernet 0 address-serve helper 30.0.0.1

#

interface ethernet id address-serve mode { relay server } show interface ethernet id address-serve mode

These commands allow you to specify or display the address serving mode for the specified Ethernet interface. The keyword relay causes the router to act as a DHCP relay agent. The keyword server enables address serving from one or more locally configured address pools.

Examples:

#interface ethernet 0 address-serve mode server #show interface ethernet 0 address-serve mode interface ethernet 0 address-serve mode server

#

interface ethernet id address-serve range { auto from-addrto-addr} no interface ethernet id address-serve range from-addrto-addrshow interface ethernet id address-serve range

This command configures a pool of IP addresses for use by the address server. You may specify one address pool for each configured Ethernet subnet (primary and secondary). The total number of addresses in all configured pools may not exceed 512 addresses.

If you specify the keyword auto instead of an IP address range, the router will automatically configure IP address pools for each configured Ethernet subnet. An automatically configured pool will include one-half of the number of addresses available in the corresponding subnet, and will be located in the opposite half of the subnet from the router's IP address on the subnet. If the total number of addresses required would exceed the maximum of 512 total addresses, the 512 available addresses will be allocated on a pro-rata basis across all pools.

interface ethernet id address-serve { no off on yes } no interface ethernet id address-serve

show interface ethernet id address-serve

These commands enable, disable, or display the status of address-serving for the specified Ethernet interface.

Stateful Inspection Configuration Commands

See also:

■“Stateful Inspection Commands” on page 3-21 for Connection Profile commands.

■“Stateful Inspection Commands” on page 2-85 for Global Stateful Inspection commands.