Netopia CLI 874 manual Motorola Netopia Router CLI Commands

Motorola Netopia® Router CLI Commands 2-117

backup failure layer-2 delay 0..65535 no backup failure layer-2 delay show backup failure layer-2 delay

Note: Beginning with Firmware Version 8.3.3, these commands are unncessary and consequently no longer supported.

These commands allow you to specify, disable, or show the layer-2 backup failure delay interval. Note that l2 is an acceptable synonym for layer-2.

backup recovery rip tx disable [ yes no ] no backup recovery rip tx disable

show backup recovery rip tx disable

Note: These commands are supported beginning with Firmware Version 8.6.1.

These commands allow you to disable, enable, or show the status of RIP services on the primary WAN interface when the Router is in Backup mode. RIP services ordinarily will continue to run on the primary interface when in Backup mode, attempting to determine “layer 2” connectivity.

Usually, the no setting is desirable, since it may be required to ping the configured host that determines “layer 2” connectivity. However, RIP running on the recovering primary interface may cause problems specific to your application. When in Backup mode, RIP routes are still sent and received through the primary interface, even though that is not the active interface.