Netopia CLI 874 manual Frame Relay Configuration Commands, Examples

Motorola Netopia® Router CLI Commands 2-101

When the DHCP client is activated on a RFC1483 MER interface, it examines the dhcp client mode in the associated connection profile (or the default profile there was no explicitly configured connection profile). If the dhcp client mode specifies standard, the DHCP client initializes the htype and hlen fields in the header of its DHCP requests to the appropriate values for an RFC1483 MER interface (htype = 1 and hlen = 6). If the dhcp client mode specifies copper-mountainor cmn, the DHCP client initializes the htype and hlen fields in the header of its DHCP requests to zero.

When the DHCP client is activated on an Ethernet WAN interface, it examines the dhcp client mode in the associated IP configuration structure, and behaves as described above for the RFC1483 MER DHCP client.

Note: cmn is accepted as a synonym for copper-mountain.

Both of these commands are supported only on hardware that has a copper mountain SDSL, IDSL, or Ethernet WAN interface!

Frame Relay Configuration Commands

Frame Relay Configuration Commands

frame-relay dlci number [ tag tag ] [ ip-addr { 0.0.0.0 remote-ip-addr} ]

[ cir { default 1-accessrate }] [ bc { default 1-accessrate }] [ be { default 0-accessrate }]

[ {disable enable} ] no frame-relay dlci number

frame-relay lmi type { none annexa annexd ansi ccitt lmi } no frame-relay lmi type

show frame-relay lmi type

frame-relay tim { none standard buffered }

show frame-relay lmi statistics

show frame-relay pvc

frame-relay dlci number [ tag tag ] [ ip-addr { 0.0.0.0 remote-ip-addr} ]

[ cir { default 1-accessrate }] [ bc { default 1-accessrate }] [ be { default 0-accessrate }] [ {disable enable} ]

This command allows you to manually configure a DLCI. If the IP address is 0.0.0.0 the router will attempt to auto-discover the remote IP address. The router supplies a default DLCI 16 with a 0.0.0.0 address, so in many cases manually configuring a DLCI is unnecessary.

Examples:

To add a DLCI using all of the default values, type:

frame-relay dlci 17