Cisco Systems 2.7 warranty Setting Up Routers and Switches, Task Procedure

Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19

Setting Up Routers and Switches

Setting Up Routers and Switches

Note Only routers and switches that have properly configured access points or bridges attached to them will be discovered.

Configure each router and switch as shown in Table 5-4 on page 5-24.

Table 5-4 Setup Procedures for Routers and Switches

Task	Procedure	Notes
1. Enable CDP and	1. In enable mode, verify that CDP is running on the	CDP is required for
verify that access	device by using one of the following commands:	the WLSE to discover
points and bridges	• On IOS-based devices—show cdp run.	the device.
are visible from the
	• On Hybrid OS-based Catalyst
router or switch.
	switches—show cdp.
	2. If CDP is not running, in global configuration mode,
	enter cdp run to enable CDP.
	3. To verify that access points or bridges are visible in
	the device’s CDP table, enter show cdp neighbors.
2. Enable SNMP	On IOS-based devices, enter configuration mode and use	SNMP is required for
and set up	the snmp community community_string ro command.	the WLSE to discover
community strings.	On Hybrid OS-based Catalyst devices, enter enable	and manage the
		device.
	mode and use the set snmp community read-only
	community_string command.

	Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
5-24	78-16345-01