Cisco Systems 2.7 Changing the Configuration After Running Setup, Mailroute hostname ip-address

Chapter 4 Basic Setup—CiscoWorks 1105/1130/1130-19

Configuring the WLSE’s Network Information

Step 6 After you finish configuring the WLSE, it will reboot. After it finishes rebooting, set up your mail server to send mail to external domains by entering the following command:

mailroute {hostname ip-address}

where hostname is the hostname of the SMTP server and ip-addressis the IP address of the SMTP server. If you do not set the mail server, email can only be sent to the local domain. For more information about this command, see the User Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.

Note You can also set up the mail server after you log in to the Web interface. See the online help or the User Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.

Changing the Configuration After Running Setup

To change the information in the setup configuration, use the following CLI commands at any time. For more information about CLI commands, see the User Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.

You can use CLI commands by connecting to the WLSE through the console or by using Telnet or SSH. Log in initially as the admin user, using the password you created during setup.

•To change the host name, use the hostname command.

•To change the domain name, use the ip-domain-namecommand.

•To change the DNS server, or add up to 2 additional DNS servers, use the ip name-servercommand.

•To configure or reconfigure an Ethernet port, use the interface command.

•To make changes in the HTTPS certificate, use the mkcert command.

Tip To change any other part of the WLSE’s initial configuration, use the erase config command to erase the previous configuration, and rerun the setup program.

	Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01	4-5