
Chapter 4 Basic
Configuring the WLSE’s Network Information
Note If you are using a Windows terminal emulator as a console, it is recommended that you use the Windows Hyper Terminal application.
Step 2 Power on the WLSE.
When the system finishes booting, a login prompt appears on the console.
Step 3 At the login prompt, enter setup.
When you boot the system for the first time, it is not configured. Logging in as setup allows you to configure the system.
Step 4 Enter responses to the first set of prompts to configure the WLSE’s connectivity. Table
Table
Prompt | Response Description | Sample Response |
|
|
|
host name: | System host name. | SolutionEngine |
|
|
|
domain name: | System domain name. | cisco.com |
|
|
|
<username> password: | Sets the password for the default user admin. Characters | wq1Cvu2pl |
| you type do not appear on screen. |
|
confirm password: |
| |
| Note Default user admin is reserved and cannot be |
|
| deleted or changed. |
|
| You can use the admin password to log into the Web |
|
| interface and and to connect via Telnet/SSH. |
|
| Password length is unlimited, and you can use the |
|
| alphanumeric characters |
|
| underscore(_). Passwords are case sensitive. |
|
|
|
|
eth0 IP address: | IP address of Ethernet 0 interface. | 209.165.200.224 |
|
|
|
eth0 network mask: | Network mask of Ethernet 0 interface. | 255.255.255.224 |
|
|
|
default gateway IP | IP address of default router. | 209.165.200.224 |
address: |
|
|
|
|
|
| Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine |
|