
Chapter 5 Setting Up
Setting Up IOS Access Points
Step 4 To configure SNMP, enter the following commands in the sequence shown. The first command includes the ISO view. The
a.Include the ISO view:
a.Configure the read-only community:
b.Configure the read/write community:
Note The community strings must also be entered on the WLSE. See Enter SNMP Community Strings for All Managed Devices, page
Caution IOS access points that do not have an ISO view will be placed in the Misconfigured Devices system group after discovery and a fault will be generated. The fault refers to a “dot 11 MIB” problem.
Step 5 (Optional) It is useful to set the system name, contact, and location SNMP variables to make the device more manageable. Use the following commands:
configuration terminal
hostname access_point
where access_point is the system name, AP_location is its location, and AP_contact is the name of the contact person.
Step 6 You can use either Telnet or SSH to push configuration templates to IOS access points. To use templates to configure IOS access points, you must configure either Telnet or SSH or both, as follows.
| Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine |
|