Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19

Setting Up IOS Access Points

Radio Management Setup Quick Reference

Table 5-2lists the high-level setup tasks and sections in this document where you can find detailed instructions.

Table 5-2 Radio Management Setup Tasks Quick Reference

Task

References

 

 

Configure WDS devices

Using Access Points as WDS Devices, page 5-12

 

Using a Wireless LAN Services Module (WSM) as the

 

WDS Device, page 5-18

 

 

Configure infrastructure access points to

Configuring Infrastructure Access Points to Register with

authenticate to a WDS device

WDS Access Points, page 5-18

 

Configuring Infrastructure Access Points to Register with

 

a Wireless LAN Services Module (WSM), page 5-20

 

 

Configure access points to be

Configuring Scanning APs, page 5-20

scanning-only APs

 

 

 

Configure the WLSE with WLCCP

Configuring the WLSE, page 5-22

credentials

 

 

 

Define authentication servers

About Configuring Authentication, page 5-11

 

 

Confirm the configuration

Confirming the Configuration, page 5-22

 

 

Using Access Points as WDS Devices

Note Before making changes to device configuration, you should back up the current configuration, and test the new configuration on non-production devices.

WDS must be active on an access point in each subnet in which APs are placed; you can also define backup WDS access points in each AP subnet. Configuring WDS requires:

Defining the AAA servers and server groups that the WDS will use to LEAP authenticate infrastructure access points and the WLSE.

Enabling WDS and set WDS priorities.

Entering the WNM IP address.

 

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine

5-12

78-16345-01

Page 90
Image 90
Cisco Systems 2.7 warranty Radio Management Setup Quick Reference, Using Access Points as WDS Devices