Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19

Setting Up IOS Access Points

Radio Management Setup—IOS Devices

Note Make sure you also configure all access points for basic network management. See Basic Network Management Setup—IOS Devices, page 5-4.

Setting up access points for radio management involves configuring all access points to register with Wireless Domain Services (WDS). WDS provides wireless client roaming and radio management aggregation.

Only Cisco Aironet 1100 and 1200 series access points support WDS. For information about the supported access points and IOS firmware versions, see the WLSE 2.7 Supported Devices Table on cisco.com.

This section contains the following information:

About WDS Devices, page 5-11

About Configuring Authentication, page 5-11

Radio Management Setup Quick Reference, page 5-12

Using Access Points as WDS Devices, page 5-12

Using a Wireless LAN Services Module (WSM) as the WDS Device, page 5-18

Configuring Infrastructure Access Points to Register with WDS Access Points, page 5-18

Configuring Infrastructure Access Points to Register with a Wireless LAN Services Module (WSM), page 5-20

Configuring Scanning APs, page 5-20

Configuring the WLSE, page 5-22

Confirming the Configuration, page 5-22

 

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine

5-10

78-16345-01

Page 88
Image 88
Cisco Systems 2.7 warranty Radio Management Setup-IOS Devices