Chapter 4 Basic Setup—CiscoWorks 1105/1130/1130-19

Configuring the Web Browser

Step 4 Enter the show config command to verify that the configuration is as you expected. For more information on this command, see the User Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.

Step 5 Enter the show clock command to verify that the system time and date are correct in Coordinated Universal Time (UTC).

If the time or date is incorrect, set the correct time and date using the clock command.

If your network uses NTP, configure the system to use NTP to set the clock.

Step 6 Enter the exit command to log out.

You are now finished using the console. The remaining steps take place at the client system.

Configuring the Web Browser

Normally, all WLSE tasks are performed in the Web interface. Before you connect to the Web interface, make sure you are using a supported browser and that the browser is properly configured.

Supported Browsers, page 4-8

Configuring Internet Explorer, page 4-9

Configuring Netscape Navigator, page 4-10

Supported Browsers

Before connecting to the WLSE web interface, make sure you are using a supported browser and the browser is properly configured. The supported browsers for WLSE 2.7 are listed in Table 4-4 on page 4-9. Use the procedures in Configuring Internet Explorer, page 4-9or Configuring Netscape Navigator, page 4-10to configure the browser.

Note Using earlier, unsupported versions of Internet Explorer compromises the security of the WLSE.

 

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine

4-8

78-16345-01

Page 72
Image 72
Cisco Systems 2.7 warranty Configuring the Web Browser, Supported Browsers