
Chapter 5 Setting Up
Setting Up IOS Access Points
Using a Wireless LAN Services Module (WSM) as the WDS Device
If you are using a WSM to provide WDS, instead of using APs for WDS, follow the procedures in the WSM documentation to configure it for WDS. Use the IP address of the WLSE as the WNM IP address.
Configuring Infrastructure Access Points to Register with WDS Access Points
Infrastructure access points initiate participation in SWAN by registering and LEAP authenticating with the WDS.
The only required configuration for infrastructure access points is the username and password used to register with the WDS.
There are three ways to configure infrastructure access points to register with WDS:
•Using the access point web
•Using the access point CLI
•Using a WLSE configuration
Using the Web Interface to Configure Infrastructure APs
To use the
Step 1 Log in to the AP’s web interface.
Step 2 Select Wireless Services > AP.
Step 3 Select Enabled.
Step 4 Enter the username and password for authenticating the infrastructure AP to the WDS.
Step 5 Click Apply.
| Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine |
|