Cisco Systems 2.7 warranty Using the AP Web Interface for Network Management Set Up

Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19

Setting Up IOS Access Points

•To enable and configure SSH, enter the following commands. In these commands, hostname is the hostname of the access point, and domain_name is your network’s domain name (for example, cisco.com). At the prompt for the number of bits in the modulus, press Return to accept the default or enter a value.

hostname hostname

ip domain-name domain_name

crypto key generate rsa

How many bits in the modulus [512]:

The following commands are recommended, but optional:

ip ssh time-out 120

ip ssh authentication-retries 3

•To configure Telnet, enter the following commands:

line 0 4

no access-class 111 in

The following commands are recommended, but optional:

width 80

length 24

Step 7 Exit global configuration mode, then enter the following command:

write memory

Using the AP Web Interface for Network Management Set Up

To configure IOS devices by using the device Web interface:

Procedure

Step 1 Log into the Web interface of the access point.

Step 2 To enable CDP, select SERVICES from the menu, then click CDP:

a.After Cisco Discovery Protocol (CDP), select Enabled.

b.Click Apply.

	Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01	5-7