
Chapter 5 Setting Up
|
| Setting Up IOS Access Points |
|
Table | |||
|
|
| |
Task | References | ||
|
|
|
|
3. | Run inventory on the WLSE. | Run Inventory, page | |
|
|
|
|
4. | Enable client registration scanning on the | Enable Client Registration Scanning, page | |
| WLSE. |
|
|
|
|
|
|
Configuring a Scanning AP—Using the AP CLI
To configure an access point for scanning only, enter the following commands:
config t
int dot11 0 (for interface 0)
Configuring a Scanning
To configure an access point for scanning only from a WLSE configuration template:
1.Select Configuration > Templates > IOS > Basic Settings, then select Scanner Access Point.
2.Select Configuration > Templates > IOS > Network Interfaces. Select a radio and select Scanner Access Point.
Run Inventory
Select Administration > Devices > Discover > Inventory and run inventory so the WLSE can update the role of the AP. The scanning APs will be listed in the WLSE’s Scanning AP system group.
For more information, see the online help or the “Managing Devices” chapter of the User Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.
Enable Client Registration Scanning
Select Radio Management > Radio Monitoring and enable Client Registration Scanning to detect
For more information, see the online help or the “Radio Management” chapter of the User Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.
| Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine |
|