HP 16500A, 16510B Connecting the Probes, Configuring the Timing Analyzer, Activity Indicators

Connecting the Probes

At this point, if you had a target system with a 4116 DRAM memory IC, you would connect the logic analyzer to your system.

Since you will be assigning Pod 1 bit 0 to the RAS label, you hook Pod 1 bit 0 to the memory IC pin connected to the RAS signal. You hook Pod 1 bit 1 to the IC pin connected to the CAS signal.

Activity Indicators

Configuring the Timing Analyzer

When the logic analyzer is connected and your target system is running, you will see two at the right-most end (least significant bits) of the Pod 1 field in the State/Timing E Configuration menu. This indicates the RAS and CAS signals are transitioning.

Activity Indicators

Figure 7-3. Activity Indicators

Now that you have configured the system, you are ready to configure the timing analyzer. You will be:

∙Creating two names (labels) for the input signals

∙Assigning the channels connected to the input signals

∙Specifying a trigger condition

Using the Timing Analyzer	HP 16510B
7 - 4	Front-Panel Reference