No labels specified. Indicates there are no labels to which to assign symbols.
(x)Occurrences Remaining in Sequence (y). Indicates the logic analyzer is waiting for (x) number of occurrences in sequence level (y) of the state trace specification before it can go on to the next sequence level.
(x)Secs Remaining in Trace. Indicates the amount of time remaining until acquisition is complete in Glitch mode.
Search failed - O pattern not found. Indicates the O pattern does not exist in the acquired data. Check for a correct O marker pattern specification.
Search failed - X pattern not found. Indicates the X pattern does not exist in the acquired data. Check for a correct X marker pattern specification.
Slow Clock or Waiting for Arm. Indicates the state analyzer is waiting for a clock or arm signal.
Slow or missing Clock. Indicates the state analyzer has not recognized a clock for 100 ms. Check for a missing clock if the intended clock is faster than 100 ms. If clock is present but is slower than 100 ms, the data will still be acquired when a clock is recognized and should be valid.
Specified inverse assembler not found. Indicates the inverse assembler specified in the configuration file cannot be found on the disc.
State clock violates overdrive specification. Indicates the data from the last acquisition is not reliable due to the state clock signal not being reliable. Check the clock threshold for proper setting and the probes for proper grounding.
(x)States Remaining to Post Store. Indicates the number of states required until memory is filled and acquisition is complete.
Time correlation of data is not possible. "Count" must be set to "Time" in both machines to properly correlate the data. This message is also displayed when the data from this state/timing module cannot be time correlated in an intermodule "Group Run" configuration.
Time from arm to trace point > 41.943 ms. The correlation counter overflows when the time from a machine’s arm to the machine’s trigger
Error Messages | HP 16510B |
|