HP 16500A manual Using the Timing Analyzer HP 16510B

3.Assign the channels connected to the input signals (Pod 1 bits 0 and

1)to the labels RAS and CAS respectively.

a. Touch the bit assignment field below Pod 1 and to the right of RAS.

b. Any combination of bits may be assigned to this pod; however, you will want only bit 0 assigned to the RAS label. The easiest way to assign bits is to touch CLEAR to un-assign any assigned bits before you start.

c. Use the knob to position the cursor on bit 0 (right most bit) in the bit assignment pop-up and touch the asterisk field. This will place an asterisk in the 0 bit. Touch DONE when the asterisk is in place.

d. Assign Pod 1 bit 1 to the CAS label by touching the CAS bit assignment field and placing the cursor on bit one and touching the asterisk. Touch DONE when complete.

Using the Timing Analyzer	HP 16510B
7 - 6	Front-Panel Reference