Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19

Setting Up IOS Access Points

In the Global Properties section:

a.Select Enable.

b.Enter the Wireless Domain Services priority. This value determines which access point will serve as the active WDS when multiple access points are configured to run WDS on the same subnet. Valid priority values are 1-255, with 255 being the highest.

c.Enter the WLSE’s IP address in the WNM IP Address field.

Step 5 Configure a server group for authenticating the SWAN infrastructure components.

In the Server Groups section:

a.Enter one or more server names or server IP addresses.

b.Under Use Group For, select Infrastructure Authentication.

c.Click Save.

Step 6 The WDS access point must also register and authenticate itself to the WDS to participate in the SWAN hierarchy, so the WDS AP is also an infrastructure AP. To authenticate and register the WDS AP as an infrastructure AP:

a.Select Wireless Services > AP Configuration.

b.Select Enabled as the Wireless Services option.

c.Enter a username and password that can be LEAP authenticated by the AAA servers in the infrastructure server group.

Step 7 (Optional) Select Preview to see a preview of the configuration template. Step 8 Select Save, then click the Save button.

Step 9 Select Yes to apply the template immediately or select No to save the template. For information on configuration jobs, see the “Managing Device Configuration” chapter in the User Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7.

Note To configure authentication for wireless clients, see the relevant AP documentation.

 

Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine

78-16345-01

5-17

Page 95
Image 95
Cisco Systems 2.7 warranty Select Wireless Services AP Configuration