3Com WX4400 3CRWX440095A WX1200, 3CRWXR10095A manual Configuring WX System Parameters

224CHAPTER 6: CONFIGURING WX SYSTEM PARAMETERS

„Not Equal

„Range

„None (no comparison is required)

cSelect the well-known port name from the Port Name drop-down list.

If the name is not in the list, select Other and type or select the port number in the Port Number box.

dIf you selected Range as the comparison operator, type or select the ending port number of the range in the Range End box. The number must be higher than the port number in the Port Number box.

eClick OK.

8Specify the TCP or UDP destination source port. The options are the same as those for the source port.

9To match based on DSCP value or IP TOS and IP precedence values: a Click on the down arrow in the DSCP column.

b Select Type Of Service or Diff-Serv Code Point.

c If you selected Type Of Service, select the IP precedence value from the Precedence drop-down list.

„Any (-1)—All packets are subject to the ACL regardless of whether precedence is set.

„Routine (0)—Packets with routine precedence are filtered.

„Priority (1)—Packets with priority precedence are filtered.

„Immediate (2)—Packets with immediate precedence are filtered.

„Flash (3)—Packets with flash precedence are filtered.

„Flash Override (4)—Packets with flash override precedence are filtered.

„CRITIC/ECP (5)—Packets with critical precedence are filtered.

„Internetwork Control (6)—Packets with internetwork control precedence are filtered.

„Network Control (7)—Packets with network control precedence are filtered.

Select the ToS value in the TOS box.

„-1(any)—All packets are subject to the ACE regardless of whether TOS is set.