3Com 3CRWXR10095A manual Feature Settings Policy, Applying Policy, Changes to Switches

Configuring Feature Settings in a Policy 375

Configuring	To configure feature settings in a policy:
Feature Settings in
a Policy

1If you have not already done so, use the procedure in “Creating a Policy” on page 374 to configure a policy and select the switches to which you want to apply the policy.

2In the Organizer panel, select a feature area.

3Use the Content panel or wizards accessed from the Task List panel to configure settings for the feature category.

To find information about a feature category, see Table 28 on page 376.

4Click Save to save the changes to the policy.

5In the Task List panel, select View to display the switches to which the policy change will apply.

6Only the settings you change from their default values are listed.

7After you review the changes, click Close.

8Correct any changes if needed, then go to “Applying Policy Changes to Switches”.

Applying Policy	To apply policy changes to WX switches:
Changes to
Switches

1Select Apply in the Task List panel to apply the changes to WX switches that are already associated with the policy.

2Review the list of switches, then click Apply to apply the changes to the switches.

The changes are automatically applied to switches you associate with the policy after making the changes.

3After the done message appears in the Apply Policy wizard, click Close.

4Repeat step 2 through step 3 for each feature category.

Table 28 on page 376 lists the section where you can find configuration information for a feature category.