3Com 3CRWXR10095A, 3CRWX120695A WXR100 manual Select the object you want to modify

Viewing and Changing Management Settings 195

bIn the Retry Count box, specify the number of times the MSS SNMP engine will resend a notification that has not been acknowledged by the target. You can specify from 0 to 3 retries. The default is 0.

16Click Finish.

Modifying a USM User, Notification Profile, or Notification Target

1Select the object you want to modify.

2Click Properties.

3Make the changes.

4Click OK.

For information about the settings you can modify, see the descriptions in the following sections:

„“Configuring a USM (SNMP V3) User” on page 189

„“Configuring a Notification Profile” on page 191

„“Configuring a Notification Target” on page 191

Configuring 3WXM Services as a Notification Target

1Access the Setup 3WXM Notification Target wizard: a Select the Configuration tool bar option.

b In the Organizer panel, click the plus sign next to the WX switch. c Click the plus sign next to System.

d Select Management Services.

e In the Task List panel, select 3WXM Notification Target.

2In the Security Model drop-down list, select the security model to use specifically for SNMP communications between the switch and 3WXM:

„USM (SNMPv3)

„V1

3If you selected USM, then select the minimum level of security for SNMP communication between the switch and 3WXM Services:

„Unsecured—SNMP message exchanges are not secure. This is the default, and is the only value supported for SNMPv1 and SNMPv2c. (This security level is the same as the noAuthNoPriv level described in SNMPv3 RFCs.)