Using the Create Wireless Switch Wizard 165

Deploying Changes To deploy all the changes, click Deploy. 3WXM compares the changes to the verification rules, and lists any warnings or error messages. If there are any errors, 3WXM will not deploy the changes. To deploy the changes, you must first resolve the errors. To resolve configuration errors, use the Verification option. (See “” on page 363.)

Using the Create

Wireless Switch

Wizard

1Access the Create Wireless Switch wizard: a Select the Configuration tool bar option.

b In the Organizer panel, select the network plan name. c In the Task List panel, select the Wireless Switch task.

2In the WX Name box, type the name of the WX switch (1 to 256 alphanumeric characters, with no spaces or tabs).

Within a network plan (and all Mobility Domains), each WX must have a unique name.

3In the WX Model list, select the WX switch model.

4In the Software Version list, select the version of Mobility System Software (MSS) you expect to run on the WX switch.

5In the Enable Password box, type the enable password for the WX.

This password must match the enable password that was defined on the switch using the CLI command set enablepass. For more information, see the Wireless LAN Switch and Controller Configuration Guide.

The password is encrypted when you type it.

6Click Next.

7Edit the IP address and network mask in the IP Address field. 3WXM will assign this IP address to the default VLAN (VLAN 1).

8Click Next.

9In the Available Members list, select the ports to add to the default VLAN and click Add or Move.

„The Add button adds the ports to the new VLAN without removing them from any other VLANs.

Page 165
Image 165
3Com 3CRWXR10095A manual Using the Create Wireless Switch Wizard, Password is encrypted when you type it Click Next