How Remote WX Configuration Works 333

Figure 9 shows the location of the Fn switch and the LED.

Figure 9 Fn Switch on WXR100

5Because the Fn switch was pressed while the switch was starting, the WXR100 configures the following items, to enable itself to contact 3WXM Services:

„Ports 1 and 2 in the default VLAN (VLAN 1)

„DHCP client on VLAN 1 enabled

6The WXR100 uses the DHCP client to obtain an IP configuration from a local DHCP server. After obtaining an IP configuration, the switch sends a DNS query for the IP address of well-known hostname wlan-config-srv.

7DNS replies with the IP address of the host where 3WXM Services are installed. The WXR100 sends a configuration request to 3WXM Services.

83WXM receives the configuration request, and looks in the currently selected network plan for a WXR100 configuration with the same serial number as the one in the configuration request.

„If the network plan contains a configuration with a matching serial number, 3WXM deploys the configuration to the switch. (See “Preconfiguring a Switch in 3WXM”.)

„If the network plan does not have a configuration with a matching serial number, one of the following occurs:

„If the Auto-Config IP Subnet Matching is enabled and other requirements are met, 3WXM can give the configuration to another switch with a different serial number, if the switch is the same model and is in the same IP subnet. (See “Replacing a Switch and Reusing its Configuration” on page 342 for more information.)

Page 333
Image 333
3Com 3CRWXR10095A, 3CRWX120695A WXR100, WX4400 3CRWX440095A WX1200 manual Shows the location of the Fn switch and the LED