3Com 3CRWXR10095A, 3CRWX120695A WXR100 manual Adding a New ACE to a Configured ACL

228CHAPTER 6: CONFIGURING WX SYSTEM PARAMETERS

Table 17 ICMP Messages and Codes (continued)

ICMP Message (Type Number)	Code (Number)
Timestamp (13)	None
Timestamp Reply (14)	None
Information Request (15)	None
Information Reply (16)	None

Adding a New ACE to a Configured ACL

To add a new ACE to a configured ACL:

1Access the ACL table:

a Select the Configuration tool bar option.

bIn the Organizer panel, click the plus sign next to the WX switch.

cClick the plus sign next to System.

dSelect ACLs.

2Select any ACE in the ACL to which you want to add the new ACE.

3In the Task List panel, select Add Rules.

4Go to step 3.

Mapping an ACL An ACL does not take effect until you map it to a user or an interface.

You can map ACLs to ports (or port groups), VLANs, or virtual ports. You cannot map an ACL to a MAP port or a wired authentication port.

You also can map ACLs to user, by configuring the filter.in and filter.out user attributes. User-based ACLs are more specific than ACLs applied to interfaces and are therefore processed first. (See “Authorization Attributes” on page 293.)

1Access the ACL table:

a Select the Configuration tool bar option.

b In the Organizer panel, click the plus sign next to the WX switch. c Click the plus sign next to System.

d Select ACLs.

2Select any ACE in the ACL you want to map.

3In the Task List panel, select ACL Mappings.