3Com 3CRWX120695A WXR100 manual Channel Number list, select the channel number for the radio

Viewing and Configuring MAPs 277

cIn the Channel Number list, select the channel number for the radio.

If RF Auto-Tuning for channel configuration is enabled, setting this value has no effect. The channel number is controlled by RF Auto-Tuning.

dIn the Transmit Power box, specify the transmit power for the radio.

If RF Auto-Tuning for power configuration is enabled, setting this value has no effect. The power level is controlled by RF Auto-Tuning.

eIf the MAP has two radios, click Next and repeat this step for the other radio. Otherwise, go to step 11.

11Click Finish.

Changing the To change the MAP-WX security mode for all Distributed MAPs, select MAP-WX Security the value from the Security Mode drop-down list:

Mode „ None—Management traffic between Distributed MAPs and the WX is not encrypted, even for MAPs that support encryption.

„Optional—Distributed MAPs can be managed by the switch even if they do not have encryption keys or their keys have not been verified by an administrator. Encryption is used for MAPs that support it.

„Require—Distributed MAPs can be managed by the switch only if they have encryption keys and their keys have been verified by an administrator. If a MAP does not have an encryption key or the key has not been verified, the WX does not establish a management session with the MAP.

The setting applies to all Distributed MAPs booted and managed by the switch. A change to this setting affects only new management sessions established after you deploy the change to the switch. The change does not affect existing sessions.

Configuring After you configure a MAP, you can select the MAP and click Properties Advanced MAP to display a configuration wizard that contains all the configurable

Settings parameters for the MAP.

You also can edit values listed in the table by editing them in the table itself.

1Access the MAP table:

a Select the Configuration tool bar option.

b In the Organizer panel, click the plus sign next to the WX switch.