340 CHAPTER 9: CONFIGURING WX SWITCHES REMOTELY
8Save the configuration changes:
WX4400# save config
success: configuration saved.
9Power off or restart the switch.
Preconfiguring a Switch in 3WXMIf you know the switch’s serial number, use the following procedure to
set up the switch’s configuration in 3WXM.
1Start 3WXM Services.
2Start a 3WXM client and connect to 3WXM Services.
3Select Tools > 3WXM Services Setup from the menu bar in the main
3WXM window. The 3WXM Services Setup wizard appears.
4On the Service Settings tab of the wizard (displayed by default), select
Allow remote access, in the Access Control area.
5Select the WX Connection Settings tab.
6Select Accept self-signed certificates, in the Connection Security area.
7Click Save, then click Close.
8Open the network plan for the site, or select File > New to create a new
network plan.
9Access the Create Wireless Switch wizard:
aSelect the Configuration tool bar option.
bIn the Organizer panel, select the network plan name.
cIn the Task List panel, select Create Wireless Switch.
10 Enter a name for the switch in the WX Name box.
11 Select the switch model.
12 Enter the serial number in the Serial Number box.
13 Configure other parameters as required for the switch’s deployment.
You can configure an enable password for the switch even if it does not
already have one. When sending the configuration, 3WXM tries the
configured password first, then tries a blank password if the enable
password does not match the one on the switch. If the switch does not
have an enable password, the blank password is accepted. 3WXM then
sends the configuration to the switch, including the configured
(non-blank) enable password.