3Com 3CRWX120695A WXR100, 3CRWXR10095A manual Configuring WX System Parameters

166CHAPTER 6: CONFIGURING WX SYSTEM PARAMETERS

„The Move button removes the ports from all other VLANs, and places them in the new VLAN.

The ports appear in the Current Members list.

10To tag ports in the VLAN, select Tag and edit the tag value.

Use this option if you used the Add button instead of the Move button to place the ports in the VLAN. For a port to be a member of more than one VLAN, the port must be tagged. By default, ports are untagged.

When you enable tagging, the default tag value is the same as the VLAN ID.

11Click Next.

12Edit the IP address to match the address of the gateway router for the default VLAN’s IP interface.

13Click Next.

14To place the switch in a Mobility Domain, select the Mobility Domain from the Mobility Domain drop-down list.

The Mobility Domain must already be created. (See “Defining a Mobility Domain” on page 60.) If you still need to create the Mobility Domain, finish creating the switch, then create the Mobility Domain.

Select the switch in the Organizer panel to display its basic settings in the Content panel, and select the Mobility Domain from the Mobility Domain drop-down list.

15To place the switch in a wiring closet, select the closet from the Wiring Closet drop-down list.

The wiring closet must already be created on a floor plan. If you still need to create the wiring closet, finish creating the switch, then create the wiring closet. The Create Wiring Closet wizard in RF Planning enables you to create a wiring closet and add the switch to it. (See “Creating a Wiring Closet” on page 111.)

If you do not select the switch when you configure the wiring closet, select the switch in the Organizer panel to display its basic settings in the Content panel, and select the wiring closet from the Wiring Closet drop-down list.

16Click Finish.